Ontor.com HVAC / Gas Heating Products / Power Venters

Home About Us HVAC Industrial Automation RoMark Division What's New Contact Us Newsletter Survey

/ /

The SWG Power Venter

The SWG Power Venter is the safest, most efficient power venter available today.

SWG Power Venters are all ETL and cETL listed for any LP gas, natural gas, or oil fired heating equipment. The SWG combines the motor, blower, and vent hood in one complete, easy to install unit. The SWG mounts on the outside of the building and pulls the combustion gas from the appliance through the outside wall utilizing 100% negative pressure.

Benefits of the SWG Power Venter include:

100% Negative pressure in the vent pipe for maximum safety.
Standard galvanized pipe can be used instead of expensive stainless steel.
No need to seal vent pipe joints, saving time, and money.
Significantly longer vent lengths than positive pressure, direct vent systems.
The SWG is recommended by major heating appliance manufacturers.

The SWG must be sized to match the appliance or appliances input firing rate. Most firing rates are published in the manufacturer's installation manual. SWG's must be installed with a CK Control Kit to ensure proper listing and safe, efficient venting.

The standard SWG Power Venter is designed for walls up to 8" thick. PEK extension kits allow the SWG to be installed in walls up to 16" thick. The PEK kit includes the inner/outer pipe extension, air flow damper and one foot of 1/4" aluminum tubing. It is available for models SWG-4 through SWG-8

PVG/PVO Power Venters

The indoor mounted PVG and PVO Power Venters provide an economical power venting system for gas and oil appliances. All controls are built into these units. A Vent Hood is required to terminate the vent system.

Accessories

SWH Vent Hoods
Designed for standard vent pipe and Class B type double-wall (B-Vent) connection. Provides proper clearance between flue gas stream and wall combustibles. Available in 3" through 8" sizes.

MG-1 Series Draft Control
Required for 80+ draft induced system applications. Available in 4" through 9" sizes.

CK-20F Water Heater Control
(Required for co-venting residential water heaters.)
Provides all system control components required to utilize the Field Power Venter with natural gas or LP Gas millivolt water heater, including safety interlock controls. This kit allows you to co-vent a residential water heater with a furnace or boiler.